Central Air Conditioner Installation in Lakewood, WA 98498

For the terrific majority of homes, central air conditioning installation is fraught and too complicated with risk to attempt without professional help. This is owing to the competence needed, the governmental wrangling of permissions and licensing requirements, and the danger of voiding warranties if the elements are set up wrongly.

What do Central Air Conditioners do?

A central air conditioner cools air in one area before dispersing it throughout the residence using the furnace’s air handling capabilities. This sets it apart from window or wall a/c or mini-split systems, which all chill relatively small areas and need lots of units to cool the entire house.

A lot of single-family homes in the United States with central air utilize a split system. This indicates that the device is divided into two parts: an evaporator coil within home and a compressor outside.

Central Air Conditioner Installation in Lakewood, WA 98498

Working With Professional Central Air Conditioner Installers in Lakewood, WA

When talking with contractors, inquire about their approach to the task. Pay attention to the questions they ask! An installer should ask clarifying questions so that your decisions and choices are represented in their estimate and completion outcome.

Planning for Central Air Installation in in Lakewood

Setting up central air conditioning is a big undertaking that requires substantial preparation ahead of time. Demand that your contractor inspect their procedure and verify that they will deal with any required licenses or other essential documents.

Go over with your professional how much you worth energy efficiency above initial expenditure. This is also an outstanding minute to go over the position of the condenser unit and the type of thermostat you select.

Sizing for your Central Air Conditioner

Your professional will assist you in figuring out the suitable size central air conditioner for your home. A unit that is too small will run practically continuously, whereas a system that is too big will chill the house too quickly and turn off prior to finishing a full cycle.

The quick on/off in the latter circumstance is taxing on the system. It can cause the evaporator coil to freeze, and a frozen coil avoids air from flowing. As a outcome, a huge air conditioning system might be less efficient at cooling than a smaller unit.

Your Air Conditioner installation will do a calculation referred to as a “Manual-J” to determine the very best system for your house. This will take into consideration all of the specifications we’ve mentioned and more, leading to the most precise size possible.

However, we understand that numerous property owners like to have a general idea of what size they require ahead of time. central air conditioning conditioner size: To get the Btu needed, increase the square video of your house’s conditioned area by 25, then divide by 12,000 to obtain the tonnage.

Keep in mind that this is merely a standard estimate, and there are several factors. If your house’s very first flooring has 12-foot ceilings, the air conditioner will have more air to chill.

Getting an Estimate for a Central Air Conditioner in Lakewood, WA 98498

contractor needs to use you an quote when you’ve discussed the standard strategy and gone over design possibilities. As always, obtain composed estimates from various suppliers. The only exception would be if you’re setting up a/c in a brand-new house, considering that the builder will more than likely manage it.

When working with a home builder or independent HVAC contractor, don’t be hesitant to seek clarifying information or demand cost breakdowns. Even if the contractor is unable to detail everything, they need to be all set to communicate adequately to help you feel more at ease with the treatment.

Central Air Conditioner Installation in Lakewood, WA 98498

The Central Air Installation Process

It should take around a day to complete the installation. The major steps are summarized here.

  • Duct work installation or modification
    • Any duct work should be limited in homes with existing furnaces or air conditioning, generally no more than an extra return line.
    • If ducts must be placed, work with your contractor to disguise them in closets or soffits to minimize expensive drywall repairs.
    • Duct work should be done before drywall is put in new construction.
  • Interior unit
    • The evaporator coil is installed within the furnace plenum.
      • The plenum is the part of the furnace on each side of the air handler where air enters and exits the home.
      • The evaporator coil will enter the supply plenum, which serves as the furnace’s “outflow.”
  • Exterior unit
    • Several considerations influence the positioning of the outside unit, including:
      • The distance between the inside unit and the electrical service panel;
      • The levelness of the ground;
      • The proximity of the loud external unit to windows or doors;
      • Distances needed by code from gas or water meters (refer to your local building department for specifics).
  • Connect the line set
    • A pair of copper pipes connects the two parts of a split system, forming the direction the refrigerant will take.
    • The most direct route from the evaporator to the condenser will primarily decide the course of the line set.
      • If you have any issues regarding the route, communicate them to the contractor as soon as possible.
      • To avoid water infiltration, the penetration to the external should be sealed.
  • Connect the Electrical Supply
    • An outside cutoff will be required for the condenser unit.
    • The electrical line will connect the condenser to the shutdown, then to the electrical service panel.
    • If your circuit panel is already overloaded, you may need to update it to withstand the extra demand of the air conditioner.
      • If the project was planned properly, any work on the panel should already be included in the project estimate.
    • There will also be a low-voltage wire connecting the condensing unit to the furnace so it can be controlled by the thermostat.
  • Condensate Drain Line
    • All air conditioners generate condensation, much like the sides of a glass of ice water. That condensation needs to be drained.
    • Units located in a basement typically run to a floor drain.
    • Units located in attics may pipe water outside, or may use a drain pan that allows water to evaporate — the same way refrigerators allow condensation to evaporate.
  • Thermostat
    • When installing central air conditioning in a new home, you must select a thermostat.
    • If you’re retrofitting central air conditioning into an older home, you may need to replace the thermostat with one that can also manage cooling.
    • This is one phase in the process that is ideal for a little do-it-yourself effort.
      • Some homeowners buy a basic thermostat for the installation and subsequently upgrade to a programmable or smart thermostat on their own.

How Much Does Central Air Installation Cost?

Costs vary based on the local market and the job details, just like any substantial project. For labor and materials, a typical split system central air conditioning installation utilizing an existing heater might cost between $3,000 and $7,000 or more. Typically, that expense will be split around 60/40, with labor accounting for most of it.

Bear in mind that you will most likely be paying full retail rather than receiving a business discount, so the whole cost of the job might not be less expensive than the contractor’s price quote. You’ll also have to perform your own sizing, and you’ll be held accountable if there are any problems with the devices.

get rid of and dispose of the old system and refrigerant if you’re changing an existing main air conditioning system. When building a furnace and cooling system, the cost of each element is regularly reduced, while the total cost of the work is higher.

Central AC Installation in Lakewood, WA 98498

Repair/Retrofit vs New Unit Installation

If boiler replacement is likely within the next few years or if you intend on transitioning to a new home heating system, you might want to give some thought to skipping the boiler retrofit and go right to setting up a brand new energy-efficient, eco-friendly heating system.

Central AC Installation in Lakewood, WA 98498

Call 855-608-3406 Now!

Central Air Conditioner Installation in Lakewood, WA

Tel:855-608-3406

Main address: PO Box 223640 Lakewood, WA
United States

Find a Central Air Conditioner specialist for buildings of all types from homes of all sizes to condo complexes, apartment buildings and offices in Lakewood, WA

Call 855-608-3406 Now!

Additional HVAC Services in Lakewood Wa 98498 Include:

Heating Services

Full-service heating services, new installs and repairs, service all makes and models, fast emergency service.

  • Boilers and Radiators - New Install
  • Boilers and Radiators - Repair
  • Commercial Heat - New Install
  • Commercial Heat - Repair
  • Electric Heat - New Install
  • Electric Heat - Repair
  • Furnaces - New Install
  • Furnaces - Repair
  • Gas Heat - New Install
  • Gas Heat - Repair
  • Geothermal Systems
  • Heat Pumps - New Install
  • Heat Pumps - Repair
  • Heating - New Install
  • Heating - Repair
  • Oil Heat - New Install
  • Oil Heat - Repair
  • Radiant Floor Systems

Air Conditioning Services

Full-service central air conditioning services, new installs, and repairs, service of all makes and models, and fast emergency service.