Central Air Conditioner Installation in San Antonio, TX 78259

For the fantastic majority of houses, central air installation is complicated and filled with risk to attempt without professional help. This is owing to the know-how required, the bureaucratic wrangling of authorizations and licensing requirements, and the danger of voiding service warranties if the elements are installed mistakenly.

What do Central Air Conditioners do?

A central air conditioner cools air in one spot before dispersing it throughout the residence using the heating system’s air handling capabilities. This sets it apart from window or wall air conditioning system or mini-split systems, which all chill reasonably tiny areas and need lots of units to cool the entire home.

Most single-family homes in the United States with central air use a split system. This implies that the gadget is divided into two parts: an evaporator coil within your home and a compressor exterior.

Central Air Conditioner Installation in San Antonio, TX 78259

Working With Professional Central Air Conditioner Installers in San Antonio, TX

When talking to professionals, ask about their technique to the task. Pay attention to the questions they ask! An installer ought to ask clarifying questions so that your decisions and preferences are represented in their estimate and completion outcome.

Planning for Central Air Installation in in San Antonio

Installing central air is a large undertaking that needs significant preparation ahead of time. Demand that your professional inspect their procedure and confirm that they will handle any needed permits or other important documentation.

Discuss with your specialist how much you value energy performance above initial expenditure. This is also an excellent minute to discuss the position of the condenser unit and the type of thermostat you choose.

Sizing for your Central Air Conditioner

Your professional will assist you in figuring out the appropriate size central air conditioning conditioner for your house. A system that is too little will run virtually constantly, whereas a system that is too big will chill the home too rapidly and shut off before finishing a full cycle.

The quick on/off in the latter situation is taxing on the system. It can trigger the evaporator coil to freeze, and a frozen coil prevents air from streaming. As a outcome, a big ac system may be less effective at cooling than a smaller system.

Your Air Conditioner installation will do a estimation referred to as a “Manual-J” to identify the very best system for your house. This will consider all of the specifications we’ve discussed and more, leading to the most precise size possible.

However, we understand that lots of house owners like to have a general idea of what size they require ahead of time. Here’s a rough estimation of central air conditioner size: To get the Btu needed, multiply the square video of your house’s conditioned location by 25, then divide by 12,000 to get the tonnage.

If you have numerous of those windows, you might require more cooling.

Getting an Estimate for a Central Air Conditioner in San Antonio, TX 78259

professional needs to offer you an estimate when you’ve reviewed the standard strategy and talked about design possibilities. As constantly, acquire written quotes from various providers. The only exception would be if you’re installing a/c in a new home, because the contractor will more than likely manage it.

Don’t be reluctant to seek clarifying information or demand expenditure breakdowns when dealing with a builder or independent HVAC professional. Even if the professional is unable to information whatever, they should be ready to interact sufficiently to assist you feel more at ease with the treatment.

Central Air Conditioner Installation in San Antonio, TX 78259

The Central Air Installation Process

It should take around a day to complete the installation. The major steps are summarized here.

  • Duct work installation or modification
    • Any duct work should be limited in homes with existing furnaces or air conditioning, generally no more than an extra return line.
    • If ducts must be placed, work with your contractor to disguise them in closets or soffits to minimize expensive drywall repairs.
    • Duct work should be done before drywall is put in new construction.
  • Interior unit
    • The evaporator coil is installed within the furnace plenum.
      • The plenum is the part of the furnace on each side of the air handler where air enters and exits the home.
      • The evaporator coil will enter the supply plenum, which serves as the furnace’s “outflow.”
  • Exterior unit
    • Several considerations influence the positioning of the outside unit, including:
      • The distance between the inside unit and the electrical service panel;
      • The levelness of the ground;
      • The proximity of the loud external unit to windows or doors;
      • Distances needed by code from gas or water meters (refer to your local building department for specifics).
  • Connect the line set
    • A pair of copper pipes connects the two parts of a split system, forming the direction the refrigerant will take.
    • The most direct route from the evaporator to the condenser will primarily decide the course of the line set.
      • If you have any issues regarding the route, communicate them to the contractor as soon as possible.
      • To avoid water infiltration, the penetration to the external should be sealed.
  • Connect the Electrical Supply
    • An outside cutoff will be required for the condenser unit.
    • The electrical line will connect the condenser to the shutdown, then to the electrical service panel.
    • If your circuit panel is already overloaded, you may need to update it to withstand the extra demand of the air conditioner.
      • If the project was planned properly, any work on the panel should already be included in the project estimate.
    • There will also be a low-voltage wire connecting the condensing unit to the furnace so it can be controlled by the thermostat.
  • Condensate Drain Line
    • All air conditioners generate condensation, much like the sides of a glass of ice water. That condensation needs to be drained.
    • Units located in a basement typically run to a floor drain.
    • Units located in attics may pipe water outside, or may use a drain pan that allows water to evaporate — the same way refrigerators allow condensation to evaporate.
  • Thermostat
    • When installing central air conditioning in a new home, you must select a thermostat.
    • If you’re retrofitting central air conditioning into an older home, you may need to replace the thermostat with one that can also manage cooling.
    • This is one phase in the process that is ideal for a little do-it-yourself effort.
      • Some homeowners buy a basic thermostat for the installation and subsequently upgrade to a programmable or smart thermostat on their own.

How Much Does Central Air Installation Cost?

Costs vary based upon the regional market and the task details, as with any considerable task. For labor and supplies, a common split system central air installation utilizing an existing heater could cost between $3,000 and $7,000 or more. On average, that cost will be divided around 60/40, with labor accounting for most of it.

Bear in mind that you will most likely be paying complete retail rather than getting a industrial discount rate, so the whole expense of the task may not be cheaper than the professional’s price quote. You’ll likewise have to perform your own sizing, and you’ll be held responsible if there are any problems with the devices.

dispose and remove of the old system and refrigerant if you’re replacing an existing main air conditioning system. When developing a furnace and a/c system, the cost of each element is frequently decreased, while the overall cost of the work is higher.

Central AC Installation in San Antonio, TX 78259

Repair/Retrofit vs New Unit Installation

If boiler replacement is likely within the next few years or if you intend on transitioning to a new home heating system, you might want to give some thought to skipping the boiler retrofit and go right to setting up a brand new energy-efficient, eco-friendly heating system.

Central AC Installation in San Antonio, TX 78259

Call 855-608-3406 Now!

Central Air Conditioner Installation in San Antonio, TX

Tel:855-608-3406

Main address: PO Box 933541 San Antonio, TX
United States

Find a Central Air Conditioner specialist for buildings of all types from homes of all sizes to condo complexes, apartment buildings and offices in San Antonio, TX

Call 855-608-3406 Now!

Additional HVAC Services in San Antonio Tx 78259 Include:

Heating Services

Full-service heating services, new installs and repairs, service all makes and models, fast emergency service.

  • Boilers and Radiators - New Install
  • Boilers and Radiators - Repair
  • Commercial Heat - New Install
  • Commercial Heat - Repair
  • Electric Heat - New Install
  • Electric Heat - Repair
  • Furnaces - New Install
  • Furnaces - Repair
  • Gas Heat - New Install
  • Gas Heat - Repair
  • Geothermal Systems
  • Heat Pumps - New Install
  • Heat Pumps - Repair
  • Heating - New Install
  • Heating - Repair
  • Oil Heat - New Install
  • Oil Heat - Repair
  • Radiant Floor Systems

Air Conditioning Services

Full-service central air conditioning services, new installs, and repairs, service of all makes and models, and fast emergency service.